The snap up holder suck on the wall with its pressure against the wall for stable suction. No drilling no hole, no sticker no viscose trace. Easy Install and Remove The snap up rack can be installed and remover quickly, so it is easy to change the rack position without damaging the wall. Space-Saving rack Save up a lot of space in the bathroom or kitchen triple corner. Purchase more to make layers of holder to meet your needs, a very practical space-saving rack. Sturdy and Durable Holder Firm ABS material and strong wall suction that can hold lots of things, maximum weight bearing is up to about 10 pounds. It is durable and can be used for a long time without deformation. And the drain hole keeps shelf away from mold and mildew. Widely Used, suitable for marble, drywall, glass,tile, virtually, almost any surface, but for best results, use on non-porous surfaces such as glass, tile or fiberglass.
Installation note: 1. The installation position requires a right angle of 90 degrees, and the installation environment requires smooth tile, glass, wood and wall. 2. When installing the product, the rubber strip should be flat on both sides, and the product should be placed horizontally in the corner. Note that the rubber strip is close to the wall but the plastic parts at both ends of the product cannot touch the wall. If the wall is touched, the whole product will be stressed unevenly. 3. Try to plug the product into the right corner corner and then shake the buckle at the bottom of the product. (When you are shkeing the buckle, try to withstand the product and not let the product move) 4. If installed in a place that often touches water. It is best not to touch the water in 12 hours after the installation is completed.